Campervan Electrical & 12V/24V Wi-Fi Power Systems

Preventing Campervan Battery Flatlines with Programmable Low-Voltage Disconnect Relays

A low-voltage disconnect sheds non-essential loads before your BMS shuts everything down — keeping the router and lights alive while the fridge waits.

Tiered load shedding with an LVDTiered load shedding with an LVDLiFePO4 bankvoltage sensedLVD relaycut at 12.2 VNon-essentialbusfridge, heater,inverterEssential busrouter, lights,pumpBMS cut-offlast resort onlyShed the big loads early so the BMS never has to switch off everything.
Schematic #32 — Preventing Campervan Battery Flatlines with Programmable Low-Voltage Disconnect Relays

Every lithium battery has a BMS that disconnects at low voltage to protect the cells. When it trips, everything goes dark: lights, water pump, router — and sometimes it takes a charger connection to wake it again. A low-voltage disconnect (LVD) is a smarter first line of defence.

The tiered approach

  1. LVD first: at a moderate threshold, disconnect high-consumption non-essential loads.
  2. Essential loads remain: lights, water pump, router and monitoring keep running.
  3. BMS last: only trips if essential loads continue far beyond expected.

Setting thresholds for LiFePO4

LiFePO4 voltage is very flat through most of its capacity, then falls quickly. A disconnect around 12.0–12.4 V under load leaves a reasonable reserve; reconnect around 13.0–13.2 V once charging starts. Confirm against your battery manufacturer's figures and your monitor's state of charge.

Use a delay

Compressor fridges and pumps cause brief voltage dips when they start. A delay of 30–90 seconds prevents nuisance disconnects.

Wiring

  • Install the LVD between the main bus and the non-essential fuse block.
  • Size it for at least 125 % of the switched load current.
  • Inverters usually have their own remote on/off; use the LVD's control output rather than switching high current.

Alarm before disconnect

Many LVDs and shunt monitors offer an alarm output. Wire a small buzzer or use the app notification to warn you minutes before shedding, giving you time to start the engine or move into sun.

Safety note: figures are typical planning values. Confirm ratings on your hardware labels and follow local electrical and radio regulations. When in doubt, have DC installations checked by a qualified auto-electrician.