Managing Wi-Fi Router Heat in Enclosed Campervan Electrical Cabinets
Routers, DC-DC chargers and inverters share one closed cabinet and cook each other. Use a thermal chimney: cool air low, hot air high, and a thermostat-controlled 12 V fan.
An electrical cabinet is the natural home for a router: it is near the battery, out of sight and close to the DC distribution. It is also where your DC-DC charger, MPPT controller and inverter dump heat. In summer, a closed cabinet can exceed 50 °C, and routers respond by throttling, dropping modems or rebooting.
The thermal chimney principle
Hot air rises. If you give it a low, cool entry and a high exit, the cabinet ventilates itself without a fan. Placing the vents on opposite corners forces air across all the components on its way through.
- Intake: low, near the floor, where the van's air is coolest.
- Exhaust: high, on the opposite side, ideally venting toward the roof fan's path.
- Free area: at least 60 cm² each. Mesh and louvres reduce free area — size up.
Arrange components by heat
- Battery low and away from heat sources — LiFePO4 prefers moderate temperatures.
- DC-DC charger and inverter in the middle with 50 mm clearance above.
- Router high but in the cool intake path, not directly above the inverter's exhaust.
Adding a fan
A quiet 80–120 mm 12 V fan on the exhaust vent, switched by a small thermostat module set to around 30 °C, costs 1–3 W only when needed. Fit the fan to extract, not blow in — extraction pulls air evenly through the whole cabinet. Fuse it at 1 A.
Monitoring
Many routers report internal temperature on their status page. Place a cheap Bluetooth thermometer next to the router and log it for a hot week. If internal temperatures exceed 70 °C or the cabinet exceeds 35 °C, improve the vents before the hardware starts failing.
Do not forget dust
Intake vents near the floor collect dust. Use a removable mesh filter and clean it monthly on dirt roads; a clogged filter quietly undoes all of this.
Safety note: figures are typical planning values. Confirm ratings on your hardware labels and follow local electrical and radio regulations. When in doubt, have DC installations checked by a qualified auto-electrician.