Low-Profile RV Air Conditioner RF Interference: Routing Telecom Cables Safely
Inverter-driven rooftop A/C units are powerful and electrically noisy. Keep antennas and coax away, separate power runs, and choose shielded cabling.
Modern low-profile rooftop air conditioners use inverter compressors for efficiency. Their switching electronics and motors can produce electrical noise that couples into nearby antennas and cables, reducing SINR on cellular links.
Recognise the symptom
Note signal quality with the A/C off, then switch it on. If SINR drops or speeds fall noticeably only when the A/C runs, interference is likely.
Antenna placement
- Keep cellular and Wi-Fi antennas as far from the A/C unit as the roof allows.
- Avoid mounting antennas directly in front of or beside the unit.
- Use the roof ground plane between them where possible.
Cable routing
- Use double-shielded, low-loss coax.
- Route coax away from A/C power and control cables.
- Where runs must cross, cross them at right angles.
- Do not bundle coax with AC wiring in the same conduit.
Filtering
Clip-on ferrites on the A/C's control lead and power feed can reduce radiated noise. Ensure the A/C chassis is properly grounded according to the manufacturer's instructions.
Power planning
Rooftop A/C draws significant power. Running it from batteries requires a large bank and inverter; most owners use it on shore power. Make sure telecom gear remains on its own fused DC circuits.
Safety note: figures are typical planning values. Confirm ratings on your hardware labels and follow local electrical and radio regulations. When in doubt, have DC installations checked by a qualified auto-electrician.