Weatherproofing Cable Entry Glands: Avoiding Roof Leaks on Rough Corrugated Roads
Washboard roads flex roofs and work cables loose. Choosing the right gland, bedding it properly, and adding strain relief so it stays sealed for years.
Roof leaks rarely come from the hole itself. They come from cables that move: every kilometre of washboard flexes the roof and tugs on cables, slowly breaking the seal. Good glands combine a proper seal with mechanical strain relief.
Choosing a gland
- Domed multi-entry glands handle several cables with individual grommets — ideal for solar, antenna and dish leads.
- Split-seal glands let you pass pre-terminated cables (with connectors) without cutting them.
- Choose UV-stable materials; cheap black plastic becomes brittle after a summer.
Installation
- Locate the gland on a flat section, not over a rib or seam.
- Drill the hole, deburr and prime the bare metal edge.
- Bed the gland on butyl tape, which stays flexible.
- Screw down evenly, then run a thin bead of MS polymer around the outside edge.
- Tighten each grommet only around the cable it is sized for. Plug unused entries.
Strain relief
Clip each cable to the roof or rack within 150 mm of the gland on the outside, and to a solid interior point on the inside. The goal is that a pull on the cable is taken by the clip, not the seal.
Drip loops
Form the cable so it dips below the gland on both sides. Water runs down the cable and drips off the low point instead of following it into the van.
Inspection
After long corrugated stretches, check for cracked sealant, loosened grommets and abrasion where cables rub on rack edges. Add split loom or spiral wrap where they touch metal.
Safety note: figures are typical planning values. Confirm ratings on your hardware labels and follow local electrical and radio regulations. When in doubt, have DC installations checked by a qualified auto-electrician.